The software automatically creates 3D points from a set of photos taken with positioned coded targets.

Each target is different and corresponds to a Number (it is similar to a Circular Barcode).

 
These Numbers are automatically read from the photo and the application creates 2D points on the images at the center of the target.

3D camera positions are then computed from 2D points on each image and finally, the 3D points are created in Rhino.

step-by-step :

1 - Position a coded target at each point that you want to Digitize.

2 - Take a series of photos of the scene and copy all these photos into an empty folder.


3 - Run the software, then the 3D reconstruction command and load a photo from the list. Click on Compute button, it's finished... Everything is automatic, after calculations (the time depends on the number of images but just a couple of minutes is usually sufficient), the 3D points are created.

4 - You can now work on the part using any powerful Rhino CAD commands... Photos can be displayed in the background during the modelisation.